0
Your Cart
0
Your Cart

This retrofit kit ONLY for the Yamaha CS-50 adds the following MIDI control:

For incoming MIDI:
Any MIDI channel can be selected
Notes (MIDI note numbers 36 96) transpose possible
Program change (numbers 1 14 top row and 17 to 30 bottom row)
Pitchbend (bends up and down a fifth)
Mod Wheel (switch to enable)
Filter cutoff frequency (of low pass filter)
Portamento
Sustain
Volume

By default:
pitchbend is controlled by pitchbend messages
mod wheel is controlled by Mod Wheel (CC#1) and also by Aftertouch messages
filter cutoff is controlled by CC#16
resonance is controlled by CC#17
Volume is controlled by MIDI volume (CC#7)
Sustain is controlled by Sustain (CC#64)
Portamento is controlled by Portamento (CC#65)

however, any controller or aftertouch or velocity can be mapped to control other things so for example velocity could be mapped to control volume.

This kit is to receive MIDI only, no MIDI can be sent from this keyboard.

Hardware:
MIDI In, & Thru sockets
Push button (for programming the MIDI setup)
Setups are stored in non-volatile memory (Eeprom)

The kit comprises the following items:
Circuit board fits in the base of the CS-50
Small pack contains DIN sockets and mounting hardware
Large pack contains cable assemblies
User instructions How to change from default settings and general instructions
Fitting instructions step by step fitting guide plus diagrams of where to connect what

All kits are fully checked and tested before despatch

Note: Our retrofit kits are not intended for installation by the end user. They should always be fitted by an experienced synth engineer, particularly this model as it is hardest of all our kits to fit.

Reviews

There are no reviews yet.

Be the first to review “Kenton Yamaha CS50 Retrofit Kit Only”

Your email address will not be published. Required fields are marked *